Rover V8 4.6 - Fuel Injectors
Posted: Sun Mar 30, 2008 1:08 pm
Some of you may remember that I was rather chuffed with some bosch injectors (BOSCH # 0 280 150 998) that I imported in from the states.
http://www.v-8.org.uk/forum/viewtopic.p ... defcd6ed51
Well today was install day, I know a long time after. The fit into the inlet manifold okay, they fit into the fuel rail okay but when all pushed together they are too short even though the seem about 1/4" long than standard! Its all to do with shape of the port side of the injector allowing it to be pushed down further than standard. The fuel rail side O-ring is just outside the recepticle.
Anyone else had this issue.
http://www.v-8.org.uk/forum/viewtopic.p ... defcd6ed51
Well today was install day, I know a long time after. The fit into the inlet manifold okay, they fit into the fuel rail okay but when all pushed together they are too short even though the seem about 1/4" long than standard! Its all to do with shape of the port side of the injector allowing it to be pushed down further than standard. The fuel rail side O-ring is just outside the recepticle.
Anyone else had this issue.