Page 1 of 1
RV8 Machine shop / Specialist
Posted: Tue Dec 11, 2007 6:02 pm
by TVRleigh
Can anyone recommend anyone in the Essex area or South East.
Would like to get my X-bolted block checked cracks etc.
Plus have new cam bearings fitted.
And have my flywheel lightened.
Thanks
Leigh
Posted: Sun Dec 16, 2007 8:42 pm
by Boosted LS1
Is Nottingham to far, j24 M1.
Mike.
Posted: Mon Dec 17, 2007 4:03 pm
by TVRleigh
Would like somone a bit closer, but depends on cost.
Anyone know if these people ok, they are local ish. not sure if they can do what I need though.
http://www.thurstonengineering.co.uk/index.htm
Posted: Tue Jan 29, 2008 1:07 am
by TVRleigh
suprized I've had no responce to this,
I'm sure you all don't do 100% of the work yourself.
Posted: Tue Jan 29, 2008 5:54 am
by ian.stewart
I use only Thurstons, even if it is an 80 mile round trip.
Posted: Tue Jan 29, 2008 8:23 am
by ChrisJC
I use Automotive Services in Northampton. Probably too far.
I've heard of Ivor Searle in Soham, but I can't remember if it was good or bad....
Chris.
Posted: Tue Jan 29, 2008 1:17 pm
by kiwicar
I used Knight racing services
http://www.knightracingservices.co.uk/ absolutely brill, very very helpfull, quality of machining A1, their advice is spot on. Trouble is for you they are in Daventry.
Mike
Posted: Wed Jan 30, 2008 11:23 am
by TVRleigh
ian.stewart wrote:I use only Thurstons, even if it is an 80 mile round trip.
going to take my block over today.