Page 1 of 1
measurement please
Posted: Fri Nov 30, 2007 3:55 pm
by bodger
can anyone tell me how long the SD1 LT77 bell housing is please :
IE: from engine to box ?
thankyou ..
Posted: Fri Nov 30, 2007 10:07 pm
by davemgb
RPi website says 18.5mm which I suspect should have been typed as 185mm.
This seems a little short to me but I don't have a bell housing to hand at the moment. I'll check in the cold harsh light of day...
Oh, this is presumably for a sportscar/SD1 since I know the four wheel drive housings are somewhat longer.
Dave
EDIT:-
Saturday afternoon now and I have measured up - 180mm.
Posted: Sat Dec 01, 2007 1:52 pm
by ian.stewart
from memort , around 171mm
Posted: Sat Dec 01, 2007 2:38 pm
by tetlow
180mm
Posted: Sat Dec 01, 2007 11:01 pm
by bodger
thanks guys ...i was hoping to use my existing bell housing ( a series one with adaptor ring ) but it's nearer 220mm
i have an old 2.0 ltr sherpa box on there and i was going to replacit with an lt77
Posted: Tue Dec 04, 2007 10:48 am
by bodger
Hello again , plan B ...now
can anyone tell me the total length from front of bell housing to output flange please ?
Posted: Tue Dec 04, 2007 6:23 pm
by chrismc
From the front of the bellhousing to the output flange- 670mm.(approx)
Posted: Sat Dec 08, 2007 1:48 am
by bodger
thankyou Chris
Posted: Tue Feb 05, 2008 11:45 am
by bodger
more measurements please ...
LT77 , front end
= from front face to the end of the input shaft
= from front face to end of splines
= from front face to end of thrust tube
= diameter of the splines ..24.9 or 25.4 ? it is 23 splines
and the length of the spigot tip
please gents