Rover V8 Crank Pulley Bolt Thread Size
Posted: Wed Jun 30, 2021 7:08 pm
Hi everyone, I am new to the forum.
I have a Rover V8 crankshaft that I am turning into a bar stool, and I plan to weld the seat to a bolt and screw the assembly into the threaded end of the crank, where the pulley would attach. However, in my infinite wisdom, I had a clearout and managed to throw away the crank pulley bolt and so now I need to find another! By my measurements, I think it is a 9/16" UNF thread, could somebody please confirm or deny this? None of my local fastener suppliers stock 9/16"s so I think it may have to be an internet job. Apologies if I haven't provided enough information, I think the engine was a 3.9L, I bought it from a scrapyard around a year ago so I have no idea what the engine came out from.
Thanks in advance
Ryan
I have a Rover V8 crankshaft that I am turning into a bar stool, and I plan to weld the seat to a bolt and screw the assembly into the threaded end of the crank, where the pulley would attach. However, in my infinite wisdom, I had a clearout and managed to throw away the crank pulley bolt and so now I need to find another! By my measurements, I think it is a 9/16" UNF thread, could somebody please confirm or deny this? None of my local fastener suppliers stock 9/16"s so I think it may have to be an internet job. Apologies if I haven't provided enough information, I think the engine was a 3.9L, I bought it from a scrapyard around a year ago so I have no idea what the engine came out from.
Thanks in advance
Ryan
