Page 1 of 1
stand alone engine wiring diagram 3,9 disco engine
Posted: Thu Nov 24, 2016 10:57 am
by roverv8bay
G'day all. I'm building a mid engine roverv8 powered VW bus. The engine is out of a 95 disco 3.9 serpentine with no cats. I would really appreciate a wiring diagram to suit the engine alone no accessories air steer cruise control. purely enough to run the engine. Thanks for any information forth coming. Being in Australia it's hard to get an easy read manual as our disco's vary in some wiring.
ernie
Posted: Thu Nov 24, 2016 2:38 pm
by DaveEFI
You'd need to say which version of the RV8. Big difference between carb and injection ones. And between injection systems.
Posted: Thu Nov 24, 2016 7:15 pm
by Ian Anderson
One post up from this
http://www.v8forum.co.uk/forum/viewtopic.php?t=149
3.9 tended to be Hotwire.
http://www.v8forum.co.uk/forum/viewtopic.php?t=13339
Two posts up will give you the tune resistor colours you will need
Ian
Posted: Fri Nov 25, 2016 4:35 am
by unstable load
Ian, do you know if that info for the resistors is also applicable to the '99 GEMS P38 Rangie engines?
Or will that engine require specific fiddling?
Posted: Fri Nov 25, 2016 6:28 am
by Ian Anderson
unstable load wrote:Ian, do you know if that info for the resistors is also applicable to the '99 GEMS P38 Rangie engines?
Or will that engine require specific fiddling?
Sorry John I have never had one of those so I do not know
Ian
Posted: Tue Nov 29, 2016 6:14 pm
by ChrisJC
You'd be wasting your time fiddling with the GEMS engines. They are super complicated.
Chris.
Posted: Wed Nov 30, 2016 4:24 am
by unstable load
Thanks, Chris!