Page 1 of 1
edelbrock performer- which gaskets
Posted: Fri Apr 08, 2016 9:23 pm
by chris-stockton
hello, just a simple q. can the gaskets below be used on my performer manifold? ive a edelbrock 4 barrel (500) going on too after a spacer. im sure my last gaskets had 4 holes?
Posted: Sat Apr 09, 2016 7:22 am
by sidecar
That gasket will be fine!
Posted: Sat Apr 09, 2016 8:33 am
by DEVONMAN
If you are intending to use that particular black spacer then I suggest you put a new gasket on top of it also as it may not seal very well with out it.
Posted: Sat Apr 09, 2016 2:04 pm
by chris-stockton
yeah, ive got two of em, just wasnt sure if it was necessary to get gaskets that seal up that centre section
Posted: Sat Apr 09, 2016 6:00 pm
by sidecar
chris-stockton wrote:yeah, ive got two of em, just wasnt sure if it was necessary to get gaskets that seal up that centre section
The gap will be so small that it will make no difference to the running of the engine. I have used open spacers before now that have been 10mm thick and you can only just tell that the throttle response is not quite as good at around 1200 RPM.
