5/16" ball end for pushrods
Posted: Sun Sep 13, 2015 11:24 pm
Any one know if you can get a 5/16" ball end for the adjustable end for the adjustable pushrods?
am sure you have already 
The V8 Owners Forum -
Welcome to the well-known V8 Owners Forum, no matter what you drive if its V8 Powered you'll be made very welcome.
https://www.v8forum.co.uk/forum/
5/16" ball end for pushrods
Page 1 of 1
Posted: Mon Sep 14, 2015 10:17 am
Tony give Real Steel a tinkle am sure you have already
am sure you have already Posted: Mon Sep 14, 2015 12:15 pm
You can for the non-adjustable end, I'm not sure if you can get two sizes for the adjustable end though!
Posted: Tue Sep 15, 2015 9:08 am
My badsidecar wrote:You can for the non-adjustable end, I'm not sure if you can get two sizes for the adjustable end though!
I see what Tony is saying, I guess you could always run them upside down with the 5/16 ends facing up and the 3/8 facing the lifters if your using hyd RV8 lifters but it will be a pain having to set the pre-loads with the intake removed 
Posted: Tue Sep 15, 2015 11:50 am
Sounds like an excuse for roller rockers to me... 
Posted: Tue Sep 15, 2015 7:02 pm