Page 1 of 1
SU carburettor throttle linkage
Posted: Sun Feb 16, 2014 6:25 pm
by 4.6_crossbolt
Does anyone know of a manufacturer or supplier of the rod linkages with sockets at either end that fit the ball connectors on HIF6's?
Burlen Fuel systems do not appear to do the short ones needed for the linkages on a Boxer quad SU set-up.
Posted: Mon Feb 17, 2014 5:54 pm
by ChrisJC
Could you get a long one cut it down and run a die down the end?
Chris.
Posted: Tue Feb 18, 2014 5:48 pm
by 4.6_crossbolt
Well, I guess that would be one way, but they're quite expensive and I'd rather not start chopping them up. Maybe I'll phone Burlens and ask if they do shorter ones. I just thought that there might be another supplier.
Posted: Tue Feb 18, 2014 7:36 pm
by 4.6_crossbolt
After searching some more on eBay I found an outfit called FastRoadCar that sell mostly Weber stuff, but also universal-fit ball-end linkage rods with threaded rod that can just be cut to size. Sorted.