Page 1 of 1
Clutch hose!!
Posted: Fri Nov 01, 2013 6:31 pm
by Ianrhall
Went to 3 motor factors today to get a flexi hose to connect to my sd1 slave cylinder-no luck. It has a 12mm 1.0 pitch thead which seemed to be the stumbling block. Any suggestions?
Ian
Posted: Fri Nov 01, 2013 8:02 pm
by Blown v8
I got Speedflow to make me a nice shiny stainless one !
Posted: Fri Nov 01, 2013 8:07 pm
by mgbv8
You could try Pirtek or Think automotive as they will make to order?
Posted: Fri Nov 01, 2013 8:36 pm
by mike-b
Try Earls at silverstone circuit, they made my master to slave on my granny to order.
jThey just need fitting reqd and length.
My hose was stainless braided and plastic coated - 36 inch long £25 - job done.
www.earls.co.uk
Posted: Fri Nov 01, 2013 10:30 pm
by bodger
use a brake flexi hose as the first part ( the caliper end fits ) and use a flare hut and bundy pipe to go down by the engine