Page 1 of 1
Water pipe connections on plenum chamber
Posted: Wed May 16, 2007 8:05 pm
by vdub boy 1
Can anyboby tell me where the two waterpipe connections ( I presume they are water pipes) that are beneath the air intake on the plenum chamber go and do I need them connected or can I just block them off?
cheers
Leigh
Posted: Thu May 17, 2007 11:51 am
by chodjinn
block them off! I have
think they are for the heater matrix
Posted: Thu May 17, 2007 12:12 pm
by ChrisJC
Presumably they keep the intake air a bit warmer than it otherwise would be.
Chris.
Posted: Sat May 19, 2007 6:57 am
by vdub boy 1
Cheers for the info
Leigh
Posted: Sat May 19, 2007 7:12 am
by Eliot
its to stop ice forming in extreeme conditions. Dont fit them.
Posted: Mon Aug 13, 2007 3:02 pm
by TVRleigh
You can remove the whole unit, but make sure you plug the two bolt holes at the back.
This will alow you to remove the rocker covers with out removing the plem.
Posted: Mon Sep 03, 2007 7:31 pm
by vdub boy 1
Cheers for the extra info, Will put that on the to do list
Thanks
Leigh
Posted: Mon Sep 03, 2007 9:45 pm
by Eliot
TVRleigh wrote:You can remove the whole unit, but make sure you plug the two bolt holes at the back.
.
Indeed, made that mistake on a mates 3.9, very rough running.