The V8 Owners Forum -

Posted: **Wed Oct 23, 2013 8:50 pm**

Does anyone know of,or has a crank damper or pulley that`s around 6 inches in diameter?
Its for a little experiment I am planning involving a v8 and an m112 supercharger.
6+7pk pulleys are easy to come by but 8pk ones seem a bit thin on the ground.
I`m based in the uk(west midlands).
I built a supercharged 1600 cvh ford with a blow thru SU carb a few years ago and it worked really well,now I have a tr7v8 with a low comp engine ive just rebuilt and want to try it again on a bigger scale.

Posted: **Thu Oct 24, 2013 9:54 am**

Hi
Is this for measuring up purposes? I have a 6 1/4 Small block chevy sfi damper off my engine at the moment as it is stripped for winter. I could lend it to you for a short while, I would need it back as it is the one for my engine! and I might be driving close by on saturday depending where you are (west midlands is a bit of a wide area.
Best regards
Mike[/b][/u]

Posted: **Thu Oct 24, 2013 5:14 pm**

Thanks for reply but I need something permanent.

Posted: **Thu Oct 24, 2013 8:44 pm**

By 8pk do you mean an 8 groove pulley?

What engine is this for?

Posted: **Thu Oct 24, 2013 9:06 pm**

im only running 7pk on my supercharged v8

Posted: **Fri Oct 25, 2013 9:03 am**

I can make you an 8PK pulley but setup times really jack up the prices on a one-off.

Posted: **Fri Oct 25, 2013 6:16 pm**

Thanks for replies but i think it may be sorted now.

The V8 Owners Forum -

8 PK SUPERCHARGER PULLEY.

8 PK SUPERCHARGER PULLEY.