Page 1 of 1
LT77 clutch.
Posted: Thu Apr 19, 2007 7:57 pm
by nickm
I have fitted an LT77 to the back of a 3.9 and when I tried to move the clutch release arm through the bellhousing[using the shank of a hammer] it feels solid.Should I be able to move the lever by hand?I want to make sure the clutch is correct before fitting it in the car.
Re: LT77 clutch.
Posted: Thu Apr 19, 2007 8:14 pm
by hearbear
nickm wrote:I have fitted an LT77 to the back of a 3.9 and when I tried to move the clutch release arm through the bellhousing[using the shank of a hammer] it feels solid.Should I be able to move the lever by hand?I want to make sure the clutch is correct before fitting it in the car.
Not tried without the slave cylinder but would be suprised if you could move with hammer shaft.
George