Page 5 of 5
Posted: Tue Feb 12, 2008 6:17 pm
by stevieturbo
I never had any rusting problems with mine.
As for smoothrite etc....Maybe its just me, but any time Ive used Hammerite paint in recent times....I think its crap.
Flakes off easy, and stuff still rusts !!!
Posted: Tue Feb 12, 2008 6:19 pm
by Coops
my timing cover, plenum, servo and front cross member are done in smoothrite black and so far touch wood, has never flaked off,
famous last words which will come back and haunt me now,
Posted: Tue Feb 12, 2008 8:14 pm
by CastleMGBV8
Tony,
Personally I wouldn't use oil as that can perish the rubber! I discovered PTFE spray whilst rebuilding the MGB and it's great for getting rubber bushings in to place. I would think Motor Factors would have it.
Kevin.
Posted: Tue Feb 12, 2008 11:11 pm
by stevieturbo
If the seals are fuel resistant, then its a sure bet its oil resistant !
If they arent fuel resistant.....I'd be worried !
Posted: Wed Feb 13, 2008 9:09 am
by CastleMGBV8
Stevie,
Your probably right, but I date back to the time when you never mixed oil and rubber, with modern synthetic products it is less critical.
Kevin.
Posted: Tue Oct 27, 2009 8:30 pm
by Coops
any one know where i can find the bosch motorsport green injector specs from?
im trying to set up the injector settings properly this time on the ecu and need to find the following,
injector open time@ 13.2V (us)
Injector effective ramp up. (us)
Injector rampup voltage compensation, (us)
Injector voltage compensation. (us)
Injector PWM DC (%)
Injector PWM peak time (ms)
dont want much do i
