Page 3 of 3
Posted: Sat Dec 27, 2008 3:43 pm
by ian.stewart
The rod I looked at has a larger Big End, I am sure they wil be available in longer lengths,
Posted: Thu Jan 22, 2009 7:57 pm
by el chapo
Hi everyone, I wonder if anyone would be to point me in the direction of a good high torque camshaft. The engine will be a 4.6 running on a hotwire EFI probably with a re-chip. This will be going into a series 3 lightweight land rover. Whilst torque is important I don’t want to limit the higher end power too much. Am I correct in thinking that in order to keep low end torque I should leave the heads standard? Does anyone have any experience of the Mark Adams chip? What sort of torque and Bhp would this setup be producing? Sorry for all the questions. Thanks James.