Page 3 of 3

Posted: Thu Jul 23, 2015 2:28 pm
by mike-b
Hi Shaun.
Yes it will require the gearbox out - a lot of work I know but if needs must .......
Unless you know for certain the state of the clutch plate I would check that too while in the same area.
regards, mike

release bearing

Posted: Fri Jul 31, 2015 5:39 am
by PershoreTVR
Thank you Mike. I'm not very hands on so work will need to be done by my garage. I think that will involve having the gearbox out? Is that the case please? I'm hoping I can defer the work until the winter (though I drive my TVR all year).

Shaun

gear noise

Posted: Sun Aug 02, 2015 6:35 am
by PershoreTVR
Turned out to be a loose bracket! Feeling mightily relieved, if not a bit daft for not checking the simple stuff first. 2 New bolts and all is fixed.

Thank you for the advice Mike.

Shaun