The V8 Owners Forum -

Ok thanks for looking I've found a company that makes new ones I will wait for your reply before I ring them , I will need a new bearing I've been told that they are very expensive, are they anything special or can I take my old one out and take it to my local bearing shop ? We have a few good one in Plymouth

DaveEFI wrote: ↑Mon Jun 18, 2018 11:52 am Must admit to surprise the P6S four speed handles the torque from a 4.6. I managed to break a few with a 3.5. Is it not possible to fit the 5 speed SD1 box? That is direct in 4th and has an overdrive 5th. So would reduce the revs with the same axle.

Hi Dave
Yes it cope well but I'm sure it's my weakest point but only time will tell haha God knows what I will do when the time comes