Page 1 of 1
Good source for brake bits:P6 3500 mongrel from 2000TC
Posted: Tue Sep 24, 2019 1:18 am
by P6B Mongrel
I’d greatly appreciate suggestions for brake rebuild kits, perhaps master & slave cyl., calipers, etc. I’m just starting on a just acquired ‘67 2000TC that was modified with a V8 and 5 speed many years ago. I think the 3-piston front calipers were not original to a TC: any suggested vendors or courses of action? I have a J Taylor manual ordered. I’m in very rural far-northern California. I don’t even know exactly what engine I have yet, but will know soon.
Thanks for any time responding. I welcome any and all direction & input.
Re: Good source for brake bits:P6 3500 mongrel from 2000TC
Posted: Thu Oct 17, 2019 11:43 pm
by unstable load
Re: Good source for brake bits:P6 3500 mongrel from 2000TC
Posted: Fri Oct 18, 2019 12:08 pm
by harvey
P6B Mongrel wrote: ↑Tue Sep 24, 2019 1:18 am
I think the 3-piston front calipers were not original to a TC: any suggested vendors or courses of action?
They are most likely calipers from the V8 P6, which IIRC are the same as E-Type jag, but readily available from the Rover specialist suppliers. Rear calipers are the same across all models apart from really early cars with a Dunlop system.
Re: Good source for brake bits:P6 3500 mongrel from 2000TC
Posted: Tue Nov 05, 2019 9:25 am
by SuperV8
This is a useful resource:
http://www.delphicat.com/WebForms/frmDelphiHome.aspx
Have a look around XJ6 -
Tom.