Supercharger rebuild
Posted: Tue Mar 18, 2014 1:17 pm
A while back my supercharger ate itself and i've been in the slow process of rebuilding/upgrading it. At the last hurdle now!
Had my new turbo compressor wheel machined and the house machined to match:
Anyone have any ideas about very high speed seals?
I'm struggling to find a seal that can cope with 80,000rpm. Works out about 60m/s but most good rubber type seals max is <20m/s.
I found one type of seal which the marketing blurb quotes a high enough surface speed but I can only buy 10 for £1000!
Dimensions are:
Seal OD 35mm
Shaft OD 15mm
5mm thick. although 7mm should fit.
The old knackered seal
I have an SKF seal of the corret size but only 20m/s surface speed spec. At the moment i'm thinking of running with this and keeping a beady eye on the oil level.
Any ideas welcome
Tom.
Had my new turbo compressor wheel machined and the house machined to match:
Anyone have any ideas about very high speed seals?
I'm struggling to find a seal that can cope with 80,000rpm. Works out about 60m/s but most good rubber type seals max is <20m/s.
I found one type of seal which the marketing blurb quotes a high enough surface speed but I can only buy 10 for £1000!
Dimensions are:
Seal OD 35mm
Shaft OD 15mm
5mm thick. although 7mm should fit.
The old knackered seal
I have an SKF seal of the corret size but only 20m/s surface speed spec. At the moment i'm thinking of running with this and keeping a beady eye on the oil level.
Any ideas welcome
Tom.