Laser cut ~RoverV8 manifold flanges.

General Chat About Exhaust, Cylinder Heads, Fuel Systems And Intake

Moderator: phpBB2 - Administrators

User avatar
stevieturbo
Forum Contributor
Forum Contributor
Posts: 3508
Joined: Sat Nov 18, 2006 6:22 pm
Location: Northern Ireland

Post by stevieturbo » Wed Sep 01, 2010 9:56 pm

What vehicle is it for ? Can you buy different manifolds and adapt them ?

Looking at JP's website it does contain lot of pics. I wouldnt exactly say the work looks outstanding by any means.

Just ok at best, although they are shiny.

My manifolds cost me circa £1300, and IMO they were a work of art. Bending, welding, everything was absolutely perfect. And that was them working from manifolds as a template, without the car being present.
Drivers side did take a couple of goes too, as it really is a tight squeeze on my car.

OJZ Engineering made them. Although you'll find they will be booked some 2-3 months in advance.


9.85 @ 144.75mph
202mph standing mile
http://www.youtube.com/watch?v=XgWRCDtiTQ0

paulmanta
Helpful or Confused
Helpful or Confused
Posts: 66
Joined: Tue Nov 21, 2006 9:07 pm

Post by paulmanta » Sat Sep 04, 2010 11:55 pm

I know the original plan was to do it myself but then i thought I would get prices for a good pro job, I will do an OK job, they ought to do a damn good job.

I am looking at both options right now.

The car is a 1986 Opel manta with a Rover V8 in it.

Post Reply

Return to “Exhaust, Cylinder Heads, Fuel And Intake Area”