I'm thinking of fitting some Weber IDF or IDA downdraughts on John Eales manifolds on my 5.0 TVR engine. Has anyone fitted these and if so, using the valve cover tops as a datum point, how far above the valve covers are the tops of the carbs. I just want to check I have enough clearance to the bonnet
Thanks in advance...Nige
Downdraughts on a TVR5.0
Moderator: phpBB2 - Administrators
- Ian Anderson
- Forum Contributor
- Posts: 2396
- Joined: Sun Nov 19, 2006 9:46 pm
- Location: Edinburgh
Re: Downdraughts on a TVR5.0
Go to gt40’s.com
Register there on
Ask the question in the relevant section.
And if no response use the search function on that site and look up cock a doodle doo Townsend he has the set up you are looking at and is a friendly chap
Ian
Register there on
Ask the question in the relevant section.
And if no response use the search function on that site and look up cock a doodle doo Townsend he has the set up you are looking at and is a friendly chap
Ian
Owner of an "On the Road" GT40 Replica by DAX powered by 3.9Hotwre Efi, worked over by DJ Motors. EFi Working but still does some kangaroo at low revs (Damn the speed limits) In to paint shop 18/03/08.