Page 1 of 1
V8 3.5 Ignition Switch Wiring.
Posted: Sun Jun 25, 2023 11:44 pm
by mart2436
I have a Sebring with a V8 3.5 engine in it.
I'm sure the wiring is from the Rover donor car.
The wires have been pulled from the ignition switch and I am
not entirely sure which ones should go where.
The pic shows the ignition switch and the terminals are arrowed
with: Battery-Ignition- ST and ACC.
The wires colours are: Red-Yellow-Black/White and Black/Blue.
I don't want to guess as I like the car and don't want anything burning out.
Thank you.
Re: V8 3.5 Ignition Switch Wiring.
Posted: Mon Jun 26, 2023 7:21 pm
by ChrisJC
They are not standard ignition colours!! You are going to have to find out where they go...
One of them will be a permanent feed from the battery which you could find with a test lamp. The other three are probably accessories, ignition, crank engine.
So dab the permanent feed on each one in turn and see what happens.
Chris.
Re: V8 3.5 Ignition Switch Wiring.
Posted: Mon Jul 10, 2023 2:42 pm
by mart2436
Yes I have followed your instructions and it all lights up and cranks over now. Thank you.