G'day all. I'm building a mid engine roverv8 powered VW bus. The engine is out of a 95 disco 3.9 serpentine with no cats. I would really appreciate a wiring diagram to suit the engine alone no accessories air steer cruise control. purely enough to run the engine. Thanks for any information forth coming. Being in Australia it's hard to get an easy read manual as our disco's vary in some wiring.
ernie
stand alone engine wiring diagram 3,9 disco engine
Moderator: phpBB2 - Administrators
-
- Newbie
- Posts: 35
- Joined: Sat Jun 29, 2013 4:48 am
- Location: Nambour queensland aussie
stand alone engine wiring diagram 3,9 disco engine
Last edited by roverv8bay on Wed Dec 27, 2017 10:04 am, edited 1 time in total.
- Ian Anderson
- Forum Contributor
- Posts: 2396
- Joined: Sun Nov 19, 2006 9:46 pm
- Location: Edinburgh
One post up from this
http://www.v8forum.co.uk/forum/viewtopic.php?t=149
3.9 tended to be Hotwire.
http://www.v8forum.co.uk/forum/viewtopic.php?t=13339
Two posts up will give you the tune resistor colours you will need
Ian
http://www.v8forum.co.uk/forum/viewtopic.php?t=149
3.9 tended to be Hotwire.
http://www.v8forum.co.uk/forum/viewtopic.php?t=13339
Two posts up will give you the tune resistor colours you will need
Ian
Owner of an "On the Road" GT40 Replica by DAX powered by 3.9Hotwre Efi, worked over by DJ Motors. EFi Working but still does some kangaroo at low revs (Damn the speed limits) In to paint shop 18/03/08.
-
- Top Dog
- Posts: 1278
- Joined: Mon May 04, 2009 6:53 am
- Ian Anderson
- Forum Contributor
- Posts: 2396
- Joined: Sun Nov 19, 2006 9:46 pm
- Location: Edinburgh
Sorry John I have never had one of those so I do not knowunstable load wrote:Ian, do you know if that info for the resistors is also applicable to the '99 GEMS P38 Rangie engines?
Or will that engine require specific fiddling?
Ian
Owner of an "On the Road" GT40 Replica by DAX powered by 3.9Hotwre Efi, worked over by DJ Motors. EFi Working but still does some kangaroo at low revs (Damn the speed limits) In to paint shop 18/03/08.