Dirt shield
Posted: Fri Aug 12, 2022 9:42 am
My engine doesn't have a dirt shield covering the flywheel and I think it should have one but not sure on which one I need?
It's a 86 engine with a BW auto bell housing (ford gearbox) ,I can see 4 potential mounting holes on the bell housing, two on the flat side at the bottom and two higher up, one lower down than the other.
Two holes in the block facing down.
Any suggestions
Thanks
Steve
It's a 86 engine with a BW auto bell housing (ford gearbox) ,I can see 4 potential mounting holes on the bell housing, two on the flat side at the bottom and two higher up, one lower down than the other.
Two holes in the block facing down.
Any suggestions
Thanks
Steve