Rover V8 clutch plate diameter
Posted: Mon Feb 11, 2019 7:34 pm
Hi,
More troubles, I was about to order a new disc for my Rover V8 engine (almost finished). I've got a complete rebuild LT77 box and seems like they use 240 mm clutch plate in the SD1 (D suffix gearbox). Unfortunately, I've just found out, my clutch and clutch cover is 266 mm. After some resource on Google it seems like it is the same diameter as a Range Rover (the clutch also has course tooth, not the fine like needed for an LT77).
Flywheel has been lightened a little and fresh rebalanced. I was hoping I could still use this flywheel but does the large 266mm clutch and clutch cover fit into the SD1 LT77 Bellhousing? Can I find a release bearing and all other parts needed to release the clutch?
regards
Dirk
More troubles, I was about to order a new disc for my Rover V8 engine (almost finished). I've got a complete rebuild LT77 box and seems like they use 240 mm clutch plate in the SD1 (D suffix gearbox). Unfortunately, I've just found out, my clutch and clutch cover is 266 mm. After some resource on Google it seems like it is the same diameter as a Range Rover (the clutch also has course tooth, not the fine like needed for an LT77).
Flywheel has been lightened a little and fresh rebalanced. I was hoping I could still use this flywheel but does the large 266mm clutch and clutch cover fit into the SD1 LT77 Bellhousing? Can I find a release bearing and all other parts needed to release the clutch?
regards
Dirk