Release bearing on T5
Posted: Sat Dec 30, 2017 1:06 am
I have a rounded metal release bearing (not flat). It is mated to a curved fingered pressure plate. Ian at RPI said it should be OK and no reason why it won't work,but it is usual to use a flat faced item.
Has anyone used this set up before? I test drove the Cob today and the clutch won't release fully. I. May need to alter the travel of the clutch fork, (spacer). But just wanted to know general feelings first.
I was struggling finding a flat faced release bearing for my T5, so after some advice used the rounded one?
Thanks Mark.
Has anyone used this set up before? I test drove the Cob today and the clutch won't release fully. I. May need to alter the travel of the clutch fork, (spacer). But just wanted to know general feelings first.
I was struggling finding a flat faced release bearing for my T5, so after some advice used the rounded one?
Thanks Mark.