The V8 Owners Forum - Forum Index The V8 Owners Forum -
Welcome to the well-known V8 Owners Forum, no matter what you drive if its V8 Powered you'll be made very welcome.
 
 GarageGarage   1/4 Mile Table1/4 Mile Table 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Twisted sanity controller

 
Post new topic   Reply to topic    The V8 Owners Forum - Forum Index -> Nitrous Oxide Area
View previous topic :: View next topic  
Author Message
billo353
Newbie
Newbie


Joined: 14 Dec 2006
Posts: 17
Location: southerner


PostPosted: Sat Jul 11, 2009 1:29 pm    Post subject: Twisted sanity controller Reply with quote

Hi, anybody know where I can download/get a copy of instuctions to fit a twisted sanity progressive controller. Thanks in advance.
Back to top
View user's profile Send private message
bones
Gold Member
Gold Member


Joined: 22 Nov 2006
Posts: 1551
Location: essex


PostPosted: Sat Jul 11, 2009 1:42 pm    Post subject: Reply with quote

Hi, is it the old type, got 3 dials on it, or the new one, ive got the old one,4 wires coming out of it Smile rich
_________________
Nightbreed racing, http://www.youtube.com/watch?v=NJoUTZ8UUps
Back to top
View user's profile Send private message
billo353
Newbie
Newbie


Joined: 14 Dec 2006
Posts: 17
Location: southerner


PostPosted: Sat Jul 11, 2009 4:11 pm    Post subject: Reply with quote

Its the old type with 3 dials, thanks.
Back to top
View user's profile Send private message
bones
Gold Member
Gold Member


Joined: 22 Nov 2006
Posts: 1551
Location: essex


PostPosted: Sat Jul 11, 2009 4:34 pm    Post subject: Reply with quote

all ive got is a rough drawing of the wiring that someone did for me, BLACK is earthed, RED to the arming switch and from that to 12v supply and to both solenoids, BLUE goes to other side of soleniods and the WHITE goes to the throttle switch,, dont know if it helps Confused rich
_________________
Nightbreed racing, http://www.youtube.com/watch?v=NJoUTZ8UUps
Back to top
View user's profile Send private message
billo353
Newbie
Newbie


Joined: 14 Dec 2006
Posts: 17
Location: southerner


PostPosted: Sat Jul 11, 2009 7:55 pm    Post subject: Reply with quote

Ta very much,I have a Sniper kit on a 427 SBC, and its all or nothing, a real handfull. I have been offered this (free!!) so thought I'll give it a try.?? thanks again,Bill.
Back to top
View user's profile Send private message
bones
Gold Member
Gold Member


Joined: 22 Nov 2006
Posts: 1551
Location: essex


PostPosted: Sat Jul 11, 2009 8:19 pm    Post subject: Reply with quote

ive got a cheater system and used the controller,but nos solenoids dont like to be pulsed,the car ran horrible, nos was on and off all down the strip. it knocks them out pretty quick aswell,and they need rebuilds about every 20 uses or so, thats why ive gone 2 stage instead, but yours could be ok Smile rich
_________________
Nightbreed racing, http://www.youtube.com/watch?v=NJoUTZ8UUps
Back to top
View user's profile Send private message
billo353
Newbie
Newbie


Joined: 14 Dec 2006
Posts: 17
Location: southerner


PostPosted: Sat Jul 11, 2009 9:00 pm    Post subject: Reply with quote

Thanks for all your advice, I will let you know if its better/worse.
Back to top
View user's profile Send private message
mgbv8
Gold Member
Gold Member


Joined: 18 Nov 2006
Posts: 5326


1975 MG MGB GT V8

PostPosted: Sun Jul 12, 2009 8:29 pm    Post subject: Reply with quote

Bill!
If you have an analogue multimeter you can test the controller.

The wiring diagram Bones has is correct so it will do you.
Mind you, I was pissed when I drew it Laughing

Set your start power to minimum. Set you final power to 100% and set your build time to around 4 seconds.

Connect your meter to the output wire and earth. When you activate the controller you should see the voltage start to rise from low volts to 12volts steady after 4 seconds.

This will give you indication that it is actually pulsing.
If you are using the small powershot solenoids on your Sniper kit it will work. But as Bones say's. They dont like being pulsed and will wear quickly.

Perry
_________________
Perry Stephenson
MGB GT + Rover V8
9.62 @ 137.37mph
Now looking for 8 seconds with a SBC engine
http://www.youtube.com/watch?v=nVscbPHgue0&list=UUqIlXfSAoiZ--GyG4tfRrjw

https://www.youtube.com/watch?v=eg3avnsNKrc&index=2&list=FLqIlXfSAoiZ--GyG4tfRrjw
Back to top
View user's profile Send private message Send e-mail
billo353
Newbie
Newbie


Joined: 14 Dec 2006
Posts: 17
Location: southerner


PostPosted: Tue Jul 14, 2009 6:54 pm    Post subject: Reply with quote

Thanks for that.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    The V8 Owners Forum - Forum Index -> Nitrous Oxide Area All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
Make payments with PayPal - it's fast, free and secure!


Copyright www.v8forum.co.uk 2006. All Rights Reserved,
Forum Disclaimer: Any posts in the V8 Forum are posted by individuals acting in their own right and do not necessarily reflect the views of the owner, administrators or moderators.